Many mechanical parts use copper castings. When the equipment is used once in the production process, there will be a certain degree of wear on the surface of the copper castings. Some of these defects can be repaired, while others are not, so we must not only judge At the same time, we must also master the repair of copper castings.
If the copper casting is damaged due to corrosion, it can be repaired with a repair welding method if it is not serious. Components such as copper castings must be repaired with brass. The corresponding material must not be cast. The material matches.
Copper casting repair welding method is to weld the required welding area before welding, remove oil, rust, oxide skin and other impurities; then partially or as a whole preheated to 250 ~ 450 degrees Celsius, and the powder is generally used powder 30i, Welding wire is usually selected silk 224 silicon brass wire.
When welding copper castings, the gas welding flame should use a slight oxidation flame or neutral flame. Pressure welding is generally used during the operation to reduce overheating of the weld metal and improve weld formation. During operation, direct contact between the high-temperature flame core and the molten pool metal should be avoided as far as possible to avoid generating pores in the weld metal. In addition, it must be insulated slowly after welding to eliminate stress and improve performance.
If the copper casting has been grinded, or if the uneven wear phenomenon is not serious, it can be polished with an emery cloth, and if the thickness permits, it can be used as a car light; or it can be restored to its original size by metal spraying. However, if the wear has exceeded the specified range, only new copper castings can be replaced if it cannot be repaired.
- Pump Reverses Some Of The Hazards
- Emergency Drainage Pump Selection
- Import And Export Of Pumps And Pipi...
- Policy Analysis Of Pump Industry
- How To Improve The Efficiency
- Specific Uses Of Water Pump
- Water Pump Installation
- Pump Operating Principle
- The General Characteristics Of A Ce...
- Considerations For Pumps
- Relevant Preventive Measures For Pr...
- Cleaning Methods And Lubrication Re...
- Influence Of Hot Sand And Temperatu...
- Copper Castings Treated By Corrosio...